Cuts not lining up when cutting long lines of vinyl

Computerized Cutting Systems and Supplies – KLIC-N-KUT Forums Cutters & Equipment KNK Zing / Air / Orbit Cuts not lining up when cutting long lines of vinyl

This topic contains 1 reply, has 2 voices, and was last updated by  Sandy 1 month, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #15404

    Alecia Fishburn
    Participant

    I am trying to cut a vinyl line about .25″ x 46″ and the vinyl seems to shift and so the end and beginning points do not match up correctly.

    Any advice on how to correct this issue would be greatly appreciated!

    Thanks in advance.

    #16789

    Sandy
    Moderator

    Make sure the pinch wheels are perfectly centered over the grit shafts below.  Keep the speed at a reasonable setting. And make sure you have at leat 1 mm overcut set in the software.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Pin It on Pinterest

Web Statistics