Tool diameters

This topic contains 2 replies, has 2 voices, and was last updated by  Sandy 4 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #19738

    Carey
    Participant

    The blade holder that came with my Orbit has a smaller diameter than the embossing, engraving, and piercing tools.  That makes it tough to combine cutting and other techniques in the same project accurately.  Do the red/yellow/blue blade holders have the same diameter as the other tools?  or are they small like the blade holder that came with my machine?

    How do you recommend getting accurate combinations of cutting and, say, piercing or embossing?

    Thanks!

    #19741

    Carey
    Participant

    Just found the section in the manual that discusses this.  (12.01.2 Draw and Cut: When the Pen and Blade Holder Are Not Aligned).  I’ll work through these steps and if I still have a question, I’ll post again.

    #19744

    Sandy
    Moderator

    Will you please contact me privately?  My email is smccauley45@cox.net. Thank you!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Pin It on Pinterest

Web Statistics