bladeholder

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #48031
    reallygroovy
    Participant

    <p style=”text-align: left;”>hi sandy, i was trying to cut something and my cutter started to act wonky. i noticed the blade in the holder was protruding more than normal. it kinda just hangs there regardless of adjusting tension. any ideas how i can fix?</p>
    thanks

    #48032
    Sandy
    Moderator

    Does the blade fall out if you shake the holder up and down (do this over a towel or something soft in case it falls).

    Remove the bottom cap and make sure nothing (such as a sliver of material) was caught up inside the holder. Blow through the cap.

    Remove the blade and then reinsert it. Push on it to make sure you have the spring retract.  Then replace the cap and try again.

    If you still have issues, test another blade holder if you have one. It could be a particular bearing has worn out.

    If you don’t have another blade holder to test, please send me an email.

     

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest