Laser light Computerized Cutting Systems and Supplies – KLIC-N-KUT › Forums › Cutters & Equipment › KNK Zing / Air / Orbit › Laser light This topic contains 1 reply, has 2 voices, and was last updated by Sandy 3 months, 1 week ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts June 15, 2018 at 11:44 am #33457 smilelyblueParticipant hi, I am trying to calibrate my KNK Zing and am not able to see the laser light, has anyone else had this problem June 15, 2018 at 12:58 pm #33458 SandyModerator A few questions first: (1) Is this the original Zing or Zing Air? Not the newer Zing Orbit? (2) Have you been using the Zing’s laser light in the past to set the origin? In other words, have you seen it work? (3) Which software are you using? The reason I ask is that you should be able to turn it on and off manually, if you’re using MTC. It could be the laser light is broken, but the answers to these questions will help. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.