Maxx Air… and sinc question.

Tagged: ,

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4328
    clarinda
    Participant

    I thought I read a statement about the blade lining up. I have always had trouble with my lines not meeting up… especially on alphabets. I always have to use a hand blade and make sure all little tabs are cut … is there some way I can fix this. I am cutting a lot of vinyl lately and it would be so much easier if I could weed with out all this work. Thanks in advance for your help.

    Clarinda

    #4367
    ron
    Moderator

    Hi Clarinda,

    I hope you are cutting vinyl without the mat; it isn’t needed for vinyl. Cut a square and evaluate the corners, and I think they might be rounded just a bit. If you increase the value of the offset, it will close cuts better, but go too far and the corners of a square will develop little peaks.

    #4465
    clarinda
    Participant

    Yes I’m cutting all my vinyl with out mats. I have this problem with all alphabets even on paper. But it causes big trouble when weeding with vinyl. I will try the corner test and reset the offset. Thanks

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest