MTC Print Preview

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #3371
    yanira
    Participant

    I recently received my zing air and successfully installed the MTC software. I have been watching tutorials to get acquainted with the software and did my first pixel trace using an online coloring page. I colored in my image and I would like to do a print and cut, but when I pull up the print preview, there is a large ‘X’ on the preview that I don’t see on the mat??? I don’t understand why this is showing? Can I get rid of it?

    #3400
    Chad Youngblut
    Keymaster

    Hi Yanira,

    Have you registered MTC yet? The X might be showing up if the software is still in demo mode.

    Hope this helps!

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest