New C3 Update and User Manual Computerized Cutting Systems and Supplies – KLIC-N-KUT › Forums › New C3 Update and User Manual This topic contains 0 replies, has 1 voice, and was last updated by Sandy 10 months, 3 weeks ago. Viewing 1 post (of 1 total) Author Posts August 28, 2017 at 7:27 pm #25897 SandyModerator A C3 update with Auto PNC has been released! Please read the following: Update 0.5.56 is ready to be installed. Instructions for using auto detection are covered in the new Section 6.08 of the Force with C3 User Manual: http://www.iloveknk.com/support/knk-force-support-page/ I’ll do my best to promptly address questions and issues if you have any problems getting automatic detection to work. And, of course, I welcome assistance from those who were testers. A big thanks, again, to all of you! Let the automatic PNCs begin! Author Posts Viewing 1 post (of 1 total) You must be logged in to reply to this topic.