Red Flashing Light At End of Boot Up

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #48302
    Shannon
    Participant

    Hi Sandy and Forum Participants,

    I have a KNK Force that is unfortunately not booting up cleanly.  When powering on I get the expected light show, but after 70 seconds the Force finishes booting with a red flashing light.  With a quick press of the power button, the Force then illuminates with a solid white light.  I can connect to C3 using Chrome and the firmware was at 0.5.40.  I updated the firmware to 0.5.57 which the C3 interface confirms.

    If I try to set a tool or send a design using either C3 or SCAL (latest update of version 4), the red flashing light comes back on.

    I did reseat the SD card in the Force, but nothing changed.  I did read about reseating the connector inside the right side panel, but before trying this would appreciate your thoughts.

    Thanks in advance for any advice/assistance!

    Shannon

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest