Won't cut properly!

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #35066
    L_morrison13
    Participant

    Hello,

    We bought a zing orbit a month or two ago we haven’t used it that often, when we first got it we try cutting card and vinyl and Mylar all cut fine, recently we have starting trying to cut card but it only cuts out in parts and not others I thought maybe the blade needed replaced so i ordered new blades but the same thing is happening also tried different types of card and getting the same result, is there something we are doing wrong it’s very frustrating!

     

    Thanks Lauren

    #35068
    Sandy
    Moderator

    If the material isn’t throughly stuck down for cutting, you’ll get inconsistent cuts. So, first, make sure you mat is still clean and sticky. If you read Section 1.08, you’ll pick up some tips on cleaning your mat and making it stickier, if needed.  If that’s not it, then please start a support ticket with KNK USA. Maybe the blade holder is the issue.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest