Zing Orbit quit reading registration marks

Computerized Cutting Systems and Supplies – KLIC-N-KUT › Forums › Cutters & Equipment › KNK Zing / Air / Orbit › Zing Orbit quit reading registration marks

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 26, 2021 at 3:30 pm #48120
    lwebb2nd
    Participant

    Working on Mac Mojave, I’ve cut hundreds of PNC designs through SCAL on my Orbit. Printed and cut 15 yesterday. This morning I can’t create new docs that Orbit can read the registration marks. Orbit firmware is up to date, upgraded to SAL 5 didn’t help? White paper, nonreflective, firm and flat on the rollers. Mark thickness and size all consistent with previous settings, Registration marks are solid dark black. I pulled up a previous doc with the same registration marks and it will read those but not any new ones I generate. What am I missing?

    June 26, 2021 at 4:05 pm #48121
    Sandy
    Moderator

    When you say you pulled up a previous doc, is it already printed from the past or a newly printed version? My point is if there’s ANY difference between a past printout and one printed today.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest